BLX-5型軟件升級使用方法

 

1 啟動時:常按住啟動按鈕,此時松開手所有輸出即刻停止。自動進入原設置參數狀態。
2 ??仄髕舳喊醋∫?仄魅我餳?,對準主機位置。0.5秒后。松開手,即進入啟動,想停止,重復此動作。
3? 球頭處啟動按鈕和2操作一樣。
4? 各牙位拍攝時間和原機相同。參照原機說明書。

軟件升級說明:
1 工作設置時間為0.5-9.9秒。自檢時間為1.2秒,不做顯示 。只有滴滴聲,拍攝設置時間和原程序相同。
2 調快時間設置速度,使用更便捷。
3 增加的自檢功能,在過流,過熱,過壓,快速啟動保 護 程序。避免燒毀球管
4 增加脈寬自動調節,射線密度和高壓比例達到最做到最小的軟射線輸出。
5 在對成像不起作用的射線輸出時間(高壓下降陡沿),接入負高壓快速停止垃圾射線輸出,更人性化的體現了對病人和醫生的呵護。
6 該程序對脈寬做了自動調節,使成像更清晰,因為有 脈寬調節和負高壓銷陡沿技術。更適合接入傳感器。

Instruction of program graded up

Start:Press"Start", if you release your hand, all input will be stopped, system will entry into orginal status
Remote start: Press and hold any key of the remote control, align the host location. 0.5 seconds. Loosen the hand, enter the start and want to stop, repeat this action
Teeth shooting time and the same as the original machine,please refer to instruction bool
Softward update:1 Set up work time is 0.5-9.9 second, self-inspection is 1.2 sec,Only drops sound, the same shot set the time and the original program.
Tune quick time to set the speed, the use of more convenient
Increase in self-test function, overcurrent, overtemperature, overvoltage, quick start saver. Tube to avoid burned
Increase the pulse width is automatically adjusted, the ray density and high pressure ratio to achieve the most to achieve the smallest soft-ray output.
Ray imaging does not work output time (high pressure decreased the sharp edge), access to negative high voltage fast stop garbage ray output reflects more humane care for patients and doctors.
The program automatically adjust the pulse width, to make the image clearer, because the pulse width modulation and negative high voltage pin steep edge technology. More suitable access to the sensor.